Use system restore when you cannot boot your systm

If your system has failed to the point where you cannot access the Windows GUI either through booting normally or through safe mode, you may still have the chance to use the System Restore feature if you have it enabled, by running it form the command prompt. To do this

Restart your computer and press F8 after the POST screen to bring up the Windows XP boot menu. Choose 'boot in safe mode with command prompt.'

If your system gets to the command prompt successfully, type '%systemroot%system32restorerstrui.exe' and then press enter. Follow the onscreen instructions to restore your computer to a previous saved point. Create a password reset disk
Here's an important tip… If you are using a password protected user account in Windows XP (and you really, really should be ) you might be nervous about forgetting your password. Well here's a way to put your mind at ease, at least a little bit. Windows XP allows users to create a password reset disk specific to their user account. This disk can be used at the welcome screen to reset your password in the event that you do forget it.

To create the disk: Go to start\control panel\user accounts. Select the account you are currently logged in as.

Under the 'related tasks' heading in the top left corner, click 'prevent a forgotten password' to open the forgotten password wizard. Insert a blank floppy disk and follow the instructions to create your password reset disk.

To use the password reset disk in case of emergency:

Once you have created a password reset disk for a specific user, the next time the password for that user is entered incorrectly at the welcome screen, a message will pop up asking if you have forgotten your password. At this point you can elect to use your password reset disk. Follow the instructions to reset your password.

Note: There are a couple of possible problems with the above procedure. For one, if you have used Windows XP's built in encryption feature to encrypt some of your files and folders, but have not yet updated to service pack 1, do not reset your password, as you will lose access to all the encrypted data. Once you have got service pack 1, it is safe to use the disk. Also, you cannot gain access to the reset feature if you have disabled the welcome screen on XP by using tip #31 above.

Keep your reset disk in a safe location, because anyone else can also use it to reset your password....



--------------------